This page is made up from the schematic on the 5200 FAQ with new pictures and explenations.
The first stage of the Luma circuit decodes the digital luminance signal and mixes in the sync.
The decoded luma is then passed though a common-collector amplifier to lower the impedance to the desired level.
The Chroma and audio outputs are strong enough not to need any amplification.
Parts:
- 100uF Capacitor
- 10uF Capacitor
- 10 ohm
- 75 ohm (2)
- 750 ohm
- 1.6 kohm
- 2 kohm
- 4.7 kohm
- 9.1 kohm
- 18 kohm
- 36 kohm
- 1N4148 low power silicon diode (CR1)
- 2N3904 or equivalent transistor
- S-Video Jack
- RCA Jack
The Below is quoted directly from the 5200 FAQ
Perhaps someone with a 5200 can take some board pics?
Where to get signals:
Most of the components do not have visible labels on the board's silkscreen, so giving component numbers is not useful. In the upper right corner of the area of the board that's covered by the shielding, there is a horizontal row of components.
o o o o o o o o o o o o
| | | | | | | | | | | |
C R3 R2 R1 D R R R R R R R
| | | | | | | | | | | |
o o o o o o o o o o o o
^ ^ ^ ^ ^ ^
| | | | | `-Chroma
| | | | `----Luma 1
| | | `-------Sync
| | `----------Luma 0
| `-------------Luma 2
`----------------Luma 3
There is a row of components to the right of the GTIA (C014805) and below a cluster of inductors and transistors.
o o o o o o o o o o o
| | | | | | | | | | |
R40 R R R R R C R R C C
| | | | | | | | | | |
o o o o o o o o o o o
^
`--Audio